These kits are huge! Once again these are not generic off the shelf typical bolts. Each one is an exact copy from the original equipment manufacturer. A typical kit would include the following: Accelerator bellcrank, rear axle retainers/rear brake plates, front brake plates, brake booster, brake cables, brake calipers, brake drums, brake hoses, spring perches, control arms, front crossmember, axle housing, differential carrier, driveshaft, engine mounts, gas cap, gas tank, filler neck, idler arm, leaf spring front eye, master cylinder, p arking brake control, pitman arm, proportioning valve, rag joint, front shocks, shock brackets, steering gear, steering linkage, strut rods, sway bar insulator brackets, transmission crossmember, transmission insulator and wheel cylinders. Remember only fasteners are included.
About Scott Drake
Scott Drake is the world's largest manufacturer and supplier of reproduction parts for classic Mustangs. Featuring thousands of quality products, Scott Drake is also one of the largest manufacturers of Ford-licensed parts. Scott Drake products are available through Mustang parts retailers, distributors, and restoration shops world-wide.
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Submodel |
Years |
Engine |
| Ford |
Mustang |
Base |
1966 |
4.7L / 289 / V8
3.3L / 200 / L6 |
| Ford |
Mustang |
Shelby GT-350H |
1966 |
4.7L / 289 / V8 |
| Ford |
Mustang |
Shelby GT-350 |
1966 |
4.7L / 289 / V8 |
STANDARD
