The product you were looking for no longer exists! Here are products you may be interested in from the same category.
This new transmission pan is made from stamped steel like the original and features a chrome finish and stock capacity. Does not come with gasket, or hardware.
…
This new transmission pan is made from stamped steel like the original and features a chrome finish and extra capacity. Approximately 1 inch deeper than stock. Does not come with gasket, or hardware.
…
For C4 Transmissions From 1965-1969
Includes A Quality Fel-Pro Gasket
Filter Features A Minute-Particulate Screen
People often forget about the fluid in their hard-working transmission. While the fluid…
Holds the transmission fluid and provides access to the filter and fluidReplaces the worn out C4 Transmission Pan to keep the transmission working properlyMade with high quality materials and chrome finish for long lasting useFeatures…
An Exact copy by Scott Drake. Natural gray paint for correct look and rust prevention.
…
Holds the transmission fluid and provides access to the filter and fluidReplaces the worn out AOD Transmission Pan to keep the transmission working properlyMade with high quality materials and chrome finish for Long lasting useFeatures…
Ford Mustang Automatic Transmission Pan - C-4 Transmission -, Chrome - Stock Depth
…
Ford Pickup Truck Transmission Pan Gasket - C4 - F100 & F250
…
Transmission Screen & Pan Gasket Kit - Cruise-O-Matic Transm,ission
…
Sold As A 17-Piece Set
For C6 Transmission Oil Pan
Correct OE-Style Hardware
…
These new transmission pans are made from cast aluminum and increase your oil capacity from two to four quarts depending on the model. Improved design over stock steel pans allows for reduced oil temperature, greater strength. Stock pans…
These new transmission pans are made from cast aluminum and increase your oil capacity from two to four quarts depending on the model. Improved design over stock steel pans allows for reduced oil temperature, greater strenGTh. Stock pans…
This pan may not fit every application listed without modification. One bolt hole might be offset about 1/8". You may have to enlongate the bolt hole in the pan to accomodate this offset.
…